Expert Interview. Dr. Tareen then completed a procedural fellowship which focused on dermatologic surgery, laser, and cosmetic dermatology. You should always contact your doctor or other qualified healthcare professional before starting, changing, or stopping any kind of health treatment. Apply an oil or lotion to see if that helps remove the adhesive. The content of this article is not intended to be a substitute for professional medical advice, examination, diagnosis, or treatment. I intended to try that but haven't bothered yet. } Rub it with a gentle towel or a cotton ball. Do not scrub it at all, just let warm water run over it when you're in the shower and use an unscented soap (I use dove sensitive skin bar soap) and the residue will come off slowly. Just put a small amount on a cotton ball, place it over the residue for a few seconds, then proceed to rub it off. callback_load: function(element) { The oils in peanut butter work the same as cooking oils to remove adhesive from your skin, and like petroleum jelly, it can provide a firmer hold while it works. The chemicals used for added fragrances can sometimes cause pain and rashes on irritated skin. Try dousing a cotton ball with some surgical spirit, available from chemists, and holding it on the sticky patch for a minute before gently rubbing off the residue. Luckily, there are many ways to remove bandage adhesive. (Read 21746 times), Adverts on this website are not endorsed by Menopause Matters, A to Z of menopause and medical conditions. Enjoy! Petroleum jelly is very hydrating and won't dry out your skin. How to Remove Glue From Hardwood Floors Without Damaging Them, How to Remove Adhesive Tape From Walls: 3 Tips & Tricks. var config = { childList: true, subtree: true }; Removing the adhesive residue left on the skin can take a lot of rubbing and will leave the skin feeling red and sore. A tattoo bandage is applied to your tattoo to heal it faster while keeping out the dirt and germs. Softer skin results in separation of the skin layers, especially during adhesive removal. To know how it works you can follow the below procedure. var bimber_front_microshare = "{\"html\":\"